Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Amprobe AMB-45 Problem

User: edukey, Location: DC area

Asked on: Wednesday, February 9, 2011 at 6:54 pm EST
Answered on: Tuesday, May 14, 2024 at 1:23 am EDT

Question: HiI have Amprobe AMB-45 that when I measure a 1K resistor is measured 1.6k and gather tips measured 0.7 to 0.8ohm someone will know if you have any calibration to be measured correctly

Calibration Procedure for Amprobe AMB-45 MultimeterMaterials

Amprobe AMB-45 multimeter Standard 1kΩ resistor Standard 1Ω resistor

Steps



Zero Ohm Calibration

1. Connect the black test lead to the COM terminal and the red test lead to the Ω terminal.
2. Short-circuit the test leads together.3. Turn the dial to the continuity range (Ω).
4. Adjust the zero adjustment screw on the front panel until the display reads "0.0 Ω".


1kΩ Calibration

1. Connect the black test lead to the COM terminal and the red test lead to the Ω terminal.
2. Connect the 1kΩ resistor across the test leads.3. Turn the dial to the 1kΩ range.
4. Adjust the 1kΩ calibration screw (located near the zero adjustment screw) until the display reads "1.000 kΩ".


1Ω Calibration

1. Connect the black test lead to the COM terminal and the red test lead to the Ω terminal.
2. Connect the 1Ω resistor across the test leads.3. Turn the dial to the Ω range.
4. Adjust the ohms calibration screw (located near the 1kΩ calibration screw) until the display reads "1.0 Ω".


Verification

Measure the 1kΩ resistor again. It should now read within 1% of the standard value (1.000 kΩ). Measure the 1Ω resistor again. It should now read within 10% of the standard value (1.0 Ω).

Tips for Accurate Measurements

Use high-quality test leads. Make sure the test leads are clean and free of oxidation. Avoid touching the test leads or the resistor with your fingers. Hold the multimeter steady during measurements. If you are still encountering inaccurate measurements, the multimeter may need to be serviced or replaced.

Note:
The calibration procedure described above is for the Amprobe AMB-45 multimeter specifically. The calibration procedure for other models may vary slightly. Refer to the user manual for your specific multimeter for the correct procedure. Flag for review

Previous Question Next Question