User: shockin
Asked on: Thursday, February 10, 2011 at 1:30 pm EST
Answered on: Tuesday, May 14, 2024 at 1:25 am EDT
Question: How does one go about intrupretting 513.3(C). The article talks about the area within 5' of the engine or tanks (wings) being a Class 1 / Div 2. In a large open hanger can a person decide that they will only be storing their plane in a specfic spot define the area accordingly, or do you have to assume that at some point they will buy additional planes, or park it somewhere else in the hanger - therefore the entire hanger becomes Class 1 / Div 2 within 10' of the floor +/-.
Interpretation of 513.3(C)
NFPA 513.3(C) states that the area within 5 feet of an aircraft engine or fuel tank is classified as Class I, Division 2. The intent of this requirement is to prevent the ignition of flammable vapors or gases that may accumulate in these areas.
Interpretation for Large Open Hangars
The interpretation of 513.3(C) in large open hangars depends on the specific circumstances. Here are two possible interpretations
1. Specific Spot Designation:
If an aircraft is consistently stored in a specific spot in the hangar and is never moved, the designated area around the aircraft can be classified as Class I, Division 2 for that specific spot. However, it is important to consider the possibility of future changes, such as the addition of new aircraft or the relocation of the aircraft to another part of the hangar.2. Entire Hangar Classification
If it is likely that aircraft will be stored or parked in different areas of the hangar, or if the specific storage location is not known, the entire hangar within 10 feet of the floor +/- should be classified as Class I, Division 2. This approach ensures a consistent level of safety regardless of where aircraft are parked or stored in the hangar.
Considerations
The decision should be based on a risk assessment considering factors such as the: Frequency and duration of aircraft storage Proximity of other potential ignition sources Ventilation and air circulation within the hangar It is advisable to consult with a qualified electrician or fire protection engineer for specific guidance. Posted hazardous location signs and appropriate electrical equipment are required for Class I, Division 2 areas.
Conclusion:
The interpretation of 513.3(C) for large open hangars should be made on a case-by-case basis, considering the specific circumstances and potential risks. If there is any uncertainty or risk of future changes, it is prudent to classify the entire hangar within 10 feet of the floor +/- as Class I, Division 2. Flag for review