Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: proper grounding of a wye-wye transformer to switchgear

User: [email protected], Location: Mission Viejo, CA

Asked on: Thursday, February 10, 2011 at 4:28 pm EST
Answered on: Tuesday, May 14, 2024 at 1:26 am EDT

Question: I am designing a switchgear installation (480Y/277) that will be fed by a Utility wye-wye 2500kva transformer. The utility intends on grounding the neutral to a ufer in the vault. They want me to bring my 11 sets of 4-500 kcmil to the transformer and connect the switchgear neutral bus to the switchgear ground bus. If I were to do that, how should I size the ground ring and electrodes at the switchgear and will that cause a problem with the neutral being grounded at two points?

Ground Ring and Electrode Sizing

For a 2500 kVA transformer, the ground ring and electrodes should be sized according to the following formula:

R = I  ρ / 2π
where: R = resistance of the ground ring (ohms) I = fault current (amps) ρ = soil resistivity (ohm-meters)Fault Current Calculations

The fault current on the primary side of the transformer can be approximated as:
I = k  S / V
where: I = fault current (amps) k = fault current multiplier (typically 10 for 3-phase faults) S = transformer rating (VA) V = transformer primary voltage (V)For a 2500 kVA transformer, the fault current is approximately:
I = 10  2500 kVA / 480 V = 5208 A
Ground Ring Sizing

Assuming a soil resistivity of 100 ohm-meters, the required resistance of the ground ring is:
R = 5208 A  100 ohm-m / 2π = 832 ohms
This corresponds to a copper ground ring with a circumference of approximately 80 feet.

Electrode Sizing

Typically, 8-foot ground rods are used for ground electrodes. The number of electrodes required can be calculated as:
N = R / R_e
where:
N = number of electrodes R = required resistance of the ground ring R_e = resistance of a single electrodeAssuming a resistance of 25 ohms for a single 8-foot ground rod, the number of electrodes required is:
N = 832 ohms / 25 ohms = 33 electrodes
Neutral Grounding

Connecting the switchgear neutral bus to the ground bus at the switchgear will create a parallel path for neutral current, which is undesirable. The neutral should only be grounded at the transformer, as per the utility's requirement.Instead, you should consider using an isolation transformer to separate the switchgear ground from the neutral. This will ensure that the neutral is only grounded at the transformer and prevent any potential issues with current flow through the switchgear ground bus. Flag for review

Previous Question Next Question