Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Square D Quad Dual Pole question

User: MikeMax, Location: Massachusetts

Asked on: Thursday, February 10, 2011 at 5:52 pm EST
Answered on: Tuesday, May 14, 2024 at 1:26 am EDT

Question: Looking to consolidate an old Challenger 20/40 panel load center plus a Challenger 16/24 sub (mounted right next to the 20/40) into a single panel as part of a basement remodel. Main is full - 36 breakers plus the feeds to the sub. Sub only has 4 single pole 20's and a dual pole for the AC. All this was from the builder/previous owner. Most of the current circuits are actually shared neutral 12/3 lines, wired two dual pole breakers. In the main panel, I have 15 dual poles (30 slots). Generally, these feed circuits in adjacent areas (example: master bedroom plugs, then master bedroom lights). A few of them are dual poles because they're 220 lines as well. I'll be adding a number of additional circuits with the basement remodel and addition of a home theater.The challenge is that Homeline doesn't offer a tandem 2-pole breaker standalone, and their quad breakers contain a 2-pole in the middle and singles on either side. So in my situation, where what I have today is mostly dual poles, if I want tandems, I need to buy 2 single poles for each tandem dual in quad format.So my (probably dumb) question: are there any issues with installing quads, but not (immediately) using some number of single-pole breakers on the quads? For example, if I buy 10 quads and fill out the 20 available tandem slots on the 40/60, and use the 10 dual poles on the quads for existing circuits, is there any issue with not using/connecting all 20 of the attached single-pole breakers initally? If I do my migration ahead of my remodel? Or could some of the singles installed on the quads be safely left unattached/dorment until they're needed after the basement remodel?Any help would be greatly appreciated. I won't be doing the actual work myself, but want to understand what equipment options I have. I'm also considering just going with the (more expensive) QO 40/60 unit, which has more tandem flexibility.

No issues with installing quads but not using all single-pole breakers

Yes, it is acceptable to install quad breakers without using all of the single-pole breakers initially. The unused single-pole breakers will not present any electrical hazards or issues.

Considerations



Neutral Bar Capacity

Ensure that the neutral bar in your new panel has sufficient capacity to handle the additional neutral wires from the unused single-pole breakers.


Panel Rating

Check the amperage rating of your new panel and ensure that it can accommodate the total current draw of all the breakers, including the unused ones.*

Future Use

Consider future expansion plans and leave some empty slots for additional breakers as needed.

Migration Plan

Your migration plan is sensible. You can install the new panel with the quads and fill out the tandem slots with dual-pole breakers for existing circuits. The unused single-pole breakers can be left unattached until you need them after the basement remodel.

QO Panel

The QO panel offers more tandem flexibility, which may be beneficial if you anticipate a significant number of tandem circuits in the future. However, it is also more expensive.

Recommendation:


Based on your description, installing quads and leaving some single-pole breakers unused is a viable option. It is important to consider the panel capacity, neutral bar capacity, and future expansion plans. If you anticipate a large number of tandem circuits in the future, the QO panel may be worth considering. However, if cost is a concern, installing quads and leaving some single-pole breakers unused is a safe and acceptable solution. Flag for review

Previous Question Next Question