Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: "Grandfathering" Older Installations

User: Ragin Cajun, Location: Upstate S.C.

Asked on: Thursday, February 10, 2011 at 9:49 pm EST
Answered on: Tuesday, May 14, 2024 at 1:27 am EDT

Question: Anybody have any guidelines on where to draw lines?I am aware of Annex H but need additional help.We have a potential job to survey a facility to document "issues". We turn in our bid Monday - a rush project.We know there are issues with OLD panelboards, and we even looked at buying a copy of UL 67, but they want nearly $1200 for the stupid thing. (Buildings go back to early '40's!) Many of the old panelboards outdoors are rusty inside and out, you can see the conductors landing on the breakers without removing the main cover, double lugging, etc.Many buildings have had multiple services installed over the years at various locations of a building as additional loads were added and at different voltages.One more thing. In "earlier" days is was common practice to jumper from one disconnect to another by double lugging. Of course, these days that's a no no. Does anybody know when this practice was ruled out??Thanks for your help!RC

Guidelines for Drawing LinesAnnex H of NFPA 70E Provides guidance on establishing electric safety program boundaries, including where to draw the line between qualified electrical workers and unqualified persons.

Additional ConsiderationsPanelboards
Rusty Panelboards

Check for exposed conductors, overheating, or signs of arcing. Consider evaluating the condition of the conductors and insulation using an infrared camera or other diagnostic tool.

Visible Conductors

May indicate improper installation or maintenance. Verify that all conductors are properly terminated and protected.

Double Lugging

Typically prohibited as it can create a loose connection and potential fire hazard.

Multiple Services
Check for proper coordination and protection between multiple services. Ensure adequate grounding and bonding. Verify conformity with current electrical codes.

Double Lugging to Jumper between Disconnects This practice was common in the past but is now considered unacceptable and dangerous. It creates a potential for a loose connection, arcing, and increased fire risk.

Additional Resources [NFPA 70E Standard for Electrical Safety in the Workplace](https://www.nfpa.org/codes-and-standards/all-codes-and-standards/list-of-codes-and-standards/detail?code=70E) [Institute of Electrical and Electronics Engineers (IEEE) 1415-2016: Recommended Practice for Electrical Safety in the Workplace](https://ieeexplore.ieee.org/document/7498537) [Occupational Safety and Health Administration (OSHA) 29 CFR 1910.303 General Requirements for Electrical Installations](https://www.osha.gov/laws-regs/regulations/standardnumber/1910/1910.303)Recommendation

Given the age and condition of the facility, it is strongly recommended to:
Hire a qualified electrical engineer to assess the potential hazards and recommend appropriate remedial actions. Conduct a thorough electrical survey using appropriate diagnostic tools, including infrared thermography and partial discharge testing. Clearly mark and remove any equipment that poses an immediate safety risk.* Develop a comprehensive plan to address the identified issues, including repairs, upgrades, and preventive maintenance. Flag for review

Previous Question Next Question