User: bullheimer, Location: WA
Asked on: Friday, February 11, 2011 at 1:15 pm EST
Answered on: Tuesday, May 14, 2024 at 1:28 am EDT
Question: although i have been doing this a number of years now, this one just fell out of the sky like a meteor!!!!almost killed me, but i got real lucky and the inspector told me about it before i covered my ditch!!! had a light/recept ckt, dryer ckt, and washer ckt in a little tiny shack and had to run 60amps to that little 10x10' MOTHER!!!!!!!!!!!!!!!!!!! AAAAAAAAHHH!all the code classes i've been to and never heard of this one. wow!! whatta kick in the pants! had to rip out 50 ft of #6 and replace it with #2 URD.(just cause that's all that was available). AAACCKKK!
Overcurrent Protection and Wire Sizing for Multiple Circuits
The National Electrical Code (NEC) requires that overcurrent protection devices (OCPDs) be sized based on the maximum current that the circuit can safely handle. For multiple circuits running in the same enclosure or raceway, the OCPD must be sized to protect all of the circuits combined.In your case, you had three circuits (lighting/receptacle, dryer, and washer) running in a small shack. The NEC requires that for multiple circuits in a single raceway or enclosure, the OCPD must be sized to protect the total ampacity of the conductors within the enclosure.Since the total load of the three circuits exceeded 60 amps, the OCPD had to be rated for at least 60 amps. You mentioned that you were originally using #6 wire, which is rated for a maximum ampacity of 55 amps. This means that your original wiring was undersized for the total load, and you were at risk of a fire or other electrical hazard.The inspector was correct to point out the code violation and require you to upgrade the wiring to #2 URD (underground residential distribution cable). This type of cable is rated for a maximum ampacity of 95 amps, which is sufficient for the total load of the three circuits.It's important to note that the requirements for multiple circuits in a single enclosure or raceway can vary depending on the specific circumstances of the installation. Always refer to the NEC or consult with a qualified electrician to ensure that your electrical system is installed and protected in accordance with code requirements. Flag for review