Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Cat 5 OR Cat 6

User: Alwayslearningelec, Location: NJ

Asked on: Friday, February 11, 2011 at 4:32 pm EST
Answered on: Tuesday, May 14, 2024 at 1:28 am EDT

Question: If the electricians are running the cabling from tel/data jack to patch panel what is usually involved. I was tols the following....besides the obvious pulling the cable, conduit, etc. I am referring to the cable only.1. tagging/labeling2. punch down @ patch panel and at jack3. testThanks.

In addition to tagging/labeling, punch down at the patch panel and jack, and testing, other tasks usually involved in running cabling from a tel/data jack to a patch panel include:1. Measuring and cutting the cable

Determine the length of cable required and cut it to the appropriate length.2.

Stripping the cable

Remove the outer jacket of the cable to expose the individual conductors.3.

Preparing the conductors

Straighten and untwist the conductors, and trim them to the correct length.4.

Installing the cable in the conduit

If the cable is being run through conduit, carefully feed it through the conduit and secure it using appropriate methods.5.

Terminating the cable at the patch panel

Connect the conductors to the appropriate terminals on the patch panel using punch-down tool.6.

Terminating the cable at the jack

Connect the conductors to the appropriate terminals on the jack using punch-down tool.7.

Testing the cable

Verify that the cable is properly terminated and functioning correctly by performing continuity and other tests.8.

Documenting the work:
Keep a record of the cables installed, including the length, type, and location. Flag for review

Previous Question Next Question