Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Another 406.4 (g) question. Divided box

User: K2X, Location: Colorado Springs

Asked on: Friday, February 11, 2011 at 11:42 pm EST
Answered on: Tuesday, May 14, 2024 at 1:30 am EDT

Question: I have a 2 gang box with a 277 light switch and a 120 light switch. The box has a divider made of a piece of cut floor tile held by a couple of gobs of glue. Built in 1960. I need to install 2 pole occupancy sensor into one side of the box and blank the other side. The sheet on the sensor says it can handle 277 and 120 at the same time and of course there are 2 hot leads and 2 neutrals and 2 manual overide buttons and I already tried one and it works fine. So I guess just knock out the divider and hook it up? Just seems strange having the 277 and 120 together. I have about a hundred to do. Thanks.

Caution

Always turn off power to the circuit before working on electrical wiring.

Assessment

The presence of a voltage divider separating the 277V and 120V circuits within the 2-gang box suggests that they are intended to be electrically isolated.

Installation Considerations

The occupancy sensor's documentation states that it can handle both 277V and 120V simultaneously. Removing the voltage divider would allow the 277V and 120V circuits to physically coexist within the same gang box. However, it's important to ensure that the circuits remain electrically isolated, as mixing 277V and 120V circuits within a single enclosure is not generally recommended.

Recommended Approach

To maintain electrical isolation and comply with best practices, it's advisable to:1.

Install a Voltage Divider

Replace the existing voltage divider with a new one made of insulating material, such as fire-rated plastic or fiberglass. This will ensure that the 277V and 120V circuits are physically separated.2.

Knock Out the Divider on the Occupancy Sensor Side

Knock out the divider on the side of the box where the occupancy sensor will be installed.3.

Install the Occupancy Sensor

Mount the occupancy sensor in the gang box, ensuring that it is correctly wired according to its instructions.4.

Blank the Other Side:
Install a blank cover plate on the remaining gang box side to prevent any electrical contact between the 277V and 120V circuits.By following these steps, you can safely install the occupancy sensor while maintaining electrical isolation between the 277V and 120V circuits. Flag for review

Previous Question Next Question