User: xformer, Location: Dallas, Tx
Asked on: Saturday, February 12, 2011 at 11:04 am EST
Answered on: Tuesday, May 14, 2024 at 1:31 am EDT
Question: I recently installed 4 - 13/ 60w cfl's in a ceiling fan along with a cfl rated slide dimmer switch. When the cfl's are dimmed to the lowest setting, they flicker or slightly strobe. anyone run into this problem? This installation was to fix a previous problem of not enough light in the room. The customer has a newly purchased ceiling fan. The fan has a wattage limiter in the light kit limiting it to 190 watts. the 4 - 40wattt lamps that came with the fan are not enough light for the living room. Any suggestions on how to fix either opportunity??
Flickering IssuePossible Causes
Incompatibility with dimmer switch
Some CFLs may not be fully compatible with all dimmer switches, especially at low settings. Ensure the dimmer switch is specifically rated for CFLs.
Overloading the dimmer
The total wattage of the CFLs (60 x 4 = 240 watts) may exceed the wattage rating of the dimmer switch.
Electrical interference
Other devices on the same circuit, such as motors or appliances, can cause electrical interference that affects CFLs.
Solutions
Use a different dimmer switch
Select a dimmer switch that is specifically designed for CFLs and has a higher wattage capacity.
Reduce the number of bulbs
Consider using fewer CFLs or bulbs with a lower wattage to reduce the total wattage.
Check for electrical interference
Turn off other devices on the same circuit and observe if the flickering persists. If it does, consult an electrician.
Insufficient Light IssuePossible Causes
Wattage limiter
The wattage limiter in the light kit restricts the total wattage of the light bulbs.
Insufficient number of bulbs
The four 40-watt bulbs may not be providing enough light for the room.
Solutions
Increase the wattage limiter
Consult the manufacturer's recommendations to determine if the wattage limiter can be increased.
Add more bulbs
Install additional bulbs to increase the total wattage and light output.*
Use higher wattage bulbs: Replace the 40-watt bulbs with higher wattage bulbs, ensuring they do not exceed the wattage limiter or the capacity of the dimmer switch. Flag for review