User: Jodonnell, Location: NY
Asked on: Sunday, February 13, 2011 at 2:06 pm EST
Answered on: Tuesday, May 14, 2024 at 1:32 am EDT
Question: Good day to all. I have been requested to provide pricing on the installation of a feeder in a hospital. The feeder is going to start of the 4th floor and run into the basement. There are electrical closets that are stacked on top of each other. We will be coring the floor and running two 3" conduits. The question I have is what do I need to do to support the conductors that are running vertical in the conduit?Thank you
Conductor Support in Vertical Conduits for Hospital FeederRequirements
National Electrical Code (NEC) Article 300.19 requires all conductors in vertical raceways to be securely supported at intervals not exceeding 1.8 m (6 ft). For conductors larger than No. 4 AWG, additional support may be required.
Support Methods
1. Cable Tray
Install a cable tray within the conduit to support the conductors. Use appropriately sized cable tray hangers to support the cable tray at the required intervals. Ensure the cable tray has sufficient strength to support the weight of the conductors.
2. Conduit Bodies and Saddles
Install conduit bodies at each floor level. Use saddles or hanger straps to secure the conduits to the conduit bodies. The saddles/straps should be spaced no more than 1.8 m (6 ft) apart.
3. Conduit Fill
Fill the conduit with a conduit fill material, such as sand or concrete, to provide additional support. The fill material should not damage the conductors or cause excessive bending.
4. Wire Mesh Basket
Install a wire mesh basket within the conduit. The basket should be designed to support the conductors and prevent them from sagging or falling.
5. Rod Hangers
Install rod hangers within the conduit. Connect the rod hangers to the conductors using wire ties or other suitable methods. The rod hangers should be spaced no more than 1.8 m (6 ft) apart and should be supported by the conduit itself or by additional hangers attached to the walls.
Additional Considerations: Use appropriate bends and radius requirements for the conduit and conductors. Avoid sharp bends that could damage the conductors. Inspect the conduit and support system regularly to ensure they are in good condition.* Follow all applicable codes and regulations, including the NEC and local building codes. Flag for review