Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: DC PROX Sens

User: ptonsparky, Location: NE (9.06 miles @5.9 Degrees from Winged Horses)

Asked on: Monday, February 14, 2011 at 5:05 pm EST
Answered on: Tuesday, May 14, 2024 at 1:35 am EDT

Question: About 10 years ago I installed a DC prox sensor on the bottom of a bucket elevator or Grain Leg. It counts the revolutions of the bottom shaft. Less than 5 counts in 3.57 seconds and the control shuts down feeding augers indicating the leg belt is slipping or the rpm is low for whatever reason. It has worked well.Problem today is while the indicator light on the sensor itself has a pretty steady pulse the actual output to PICO controller is a repition of pulse..pulse...(skip)...pulse..pulse...(skip) which of course causes the count to be off within a few seconds. Seems like an odd way to fail. Anyone with a thought?

Potential Causes of Pulsed Output



Sensor Misalignment

Ensure the sensor is properly aligned with the shaft, as any deviation can result in inconsistent pulse detection.


Damaged Sensor

Inspect the sensor for any physical damage, such as a broken wire or a loose connection.

Electrical Interference

Check for potential electrical interference from other equipment or nearby electrical lines that could be affecting the sensor's output.


Defective Output Circuit

The output circuit within the sensor may be faulty, causing the intermittent output.

Aging Capacitors

Capacitors in the sensor's circuitry can degrade over time, leading to erratic output.


Poor Grounding

An inadequate ground connection can interfere with the sensor's operation.*

Faulty PICO Controller Input

The input circuitry of the PICO controller could be malfunctioning, causing it to register only alternate pulses.

Troubleshooting Steps

1.

Check Alignment and Inspect Sensor

Ensure proper alignment and inspect the sensor for damage.2.

Test with Multimeter

Use a multimeter to check the voltage and resistance across the sensor's output terminals. Compare the readings to the manufacturer's specifications.3.

Isolate Electrical Interference

Temporarily move the sensor away from potential sources of interference to see if the output becomes consistent.4.

Replace Output Circuit

If the voltage and resistance checks are satisfactory, consider replacing the output circuit in the sensor.5.

Check PICO Controller Input

Verify that the input circuit of the PICO controller is receiving a clean, undistorted signal from the sensor.6.

Review Grounding

Ensure that the sensor is properly grounded and that the ground connection is adequate.7.

Consider Capacitor Replacement:
If the sensor has been in service for an extended period, replacing capacitors in its circuitry may be necessary. Flag for review

Previous Question Next Question