Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: small 480 panel

User: Open Neutral, Location: Inside the Beltway

Asked on: Monday, February 14, 2011 at 6:39 pm EST
Answered on: Tuesday, May 14, 2024 at 1:35 am EDT

Question: Have a case where an outbuilding ('the shed") will be ~800 ft from the main building, and needs routine generic power, i.e. say two 15 or 20A circuits. We have to run 480v to a building ("the barn") 300 ft of that distance, to run a VFD. I suggested we could extend the 480 the rest of the way to the shed, to reduce the conductors and voltage drop; and put a small stepdown in the shed.The electrician says if we have more than that sole VFD 480 load, we'll need a 480V panelboard in the barn, and that's $800. I assume that's because most 480 panels are 3-phase, etc. Is there a less expensive solution for two single-phase 480v circuits; one for the VFD, the other for the line to the shed?(This is in California, so the electrons must be politically correct....)

Yes, there is a less expensive solution



Use a 480V to 120/240V Single-Phase Transformer
Install a 480V to 120/240V single-phase transformer in the barn. This will step down the voltage to a usable level for your single-phase loads. Connect the transformer to the 480V line and run 120/240V wiring to the shed. Install a small subpanel in the shed to distribute power to your two circuits.

Benefits



Cost-effective

A single-phase transformer is typically less expensive than a 480V panelboard.

Simple installation

The transformer can be installed relatively easily, without the need for additional wiring or conduit.


Compact size

Transformers are more compact than panelboards, saving space in your barn.

Additional Considerations

Ensure that the transformer is sized appropriately for the load. Properly install and ground the transformer according to code. Consider surge protection for the transformer.

Estimated Cost

480V to 120/240V single-phase transformer: $200-$500 Subpanel in the shed: $100-$200 Wiring and installation: $200-$500

Total:
Approximately $500-$1200This solution is significantly less expensive than installing a 480V panelboard and provides a safe and reliable way to power your single-phase loads in the shed. Flag for review

Previous Question Next Question