Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: electrical design questions

User: james_mcquade, Location: Northern illinois

Asked on: Tuesday, February 15, 2011 at 10:17 am EST
Answered on: Tuesday, May 14, 2024 at 1:36 am EDT

Question: Hi all,I had a rush meeting with a customer i regards to some work he wants an i left my code book behind.I have 2 questions and would appreciate any help you can give.#1 What is the code reference for conduit seals in regards to the fill size?I remember reading its 25% but i cannot cite the code.#2 What is the code reference for placing pneumatic valves in the same enclosure as the plc.One valve will have water in the line and the other will have air to dry off the parts. i tole him its bad practice andthe consequences, but he wants book, chapter and verse.thanks,James

#1 Code Reference for Conduit Seals in Regards to Fill Size

NEC 373.6(C)(2)Requirement

Conduit seals are required when the conduit fill exceeds 25% of the internal cross-sectional area of the conduit.#2

Code Reference for Placing Pneumatic Valves in the Same Enclosure as the PLC


There is no specific code reference prohibiting the placement of pneumatic valves in the same enclosure as a PLC. However, it is generally considered best practice to avoid this arrangement due to the potential for electrical interference and the risk of water or air leaks damaging the PLC.

Relevant Code Sections

NEC 430.14: Electrical Equipment in Hazardous (Classified) Locations NEC 501.13: Electrical Equipment in Hazardous (Classified) Locations NFPA 70E: Standard for Electrical Safety in the Workplace

Recommended Practice:


It is recommended to install pneumatic valves in a separate enclosure from the PLC, especially if one of the valves will be handling water. This arrangement will minimize the risk of electrical interference and damage to the PLC. If it is not possible to install the valves in separate enclosures, the following precautions should be taken:
Use a sealed enclosure to prevent water or air leaks from entering the PLC enclosure. Install the PLC and valves as far apart as possible within the enclosure. Use shielded cables to connect the PLC to the valves.* Ground the PLC and valves properly. Flag for review

Previous Question Next Question