User: bigboto69, Location: Hilo, HI
Asked on: Tuesday, February 15, 2011 at 11:49 am EST
Answered on: Tuesday, May 14, 2024 at 1:36 am EDT
Question: What is an adequate spacing between cables to avoid having to derate? Are romex stackers spaced far enough to avoid derating? What about SE cables? (Think of an apartment building) Being that we can't run feeders through units, we need to stay in corridors to run our feeders, what would be the minimum distance between cables to avoid the derating? Where can I reference in the code for these questions?
Adequate Spacing to Avoid Derating
According to NEC Article 310.15(B)(3)(a), conductors in free air must be spaced as follows to avoid derating: Not less than 24 inches (610 mm) for paralleling lengths of 3 feet (900 mm) or more Not less than 12 inches (305 mm) for paralleling lengths less than 3 feet (900 mm)Romex Stackers
Romex stackers typically have spacing between cables that meet the requirements of NEC 310.15(B)(3)(a). Therefore, they are generally spaced far enough apart to avoid derating.
SE Cables
SE cables have a higher allowable ampacity than Romex, so they can be spaced more closely together. However, if SE cables are paralleled for longer distances, they should be spaced according to the requirements of NEC 310.15(B)(3)(a) to avoid derating.
Minimum Distance Between Cables in Corridors
In apartment buildings, feeders are often run through corridors. To avoid derating cables due to close proximity, it is recommended to maintain a minimum distance of 12 inches (305 mm) between parallel runs of cables. This is consistent with the requirements for paralleling lengths less than 3 feet (900 mm) in NEC 310.15(B)(3)(a).
Code References* NEC Article 310.15(B)(3)(a): Conductor Spacing for Overcurrent Protection Flag for review