Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Calculating Maximum Wire Size in Modular Metering

User: Zeus32, Location: Chapel Hill, NC

Asked on: Tuesday, February 15, 2011 at 2:39 pm EST
Answered on: Tuesday, May 14, 2024 at 1:37 am EDT

Question: I am an electrical contractor who specializes in mult-family projects. Recently, we have been wiring mixed-use and high-density apartment projects. These projects, unlike your typical garden style apartments, have significantly longer SER/subfeeder runs to the unit panels due to meterbase locations being more spread out. We typically use Square D EZM Modular Metering rated at 125 Amps, example, a Square D EZMR115125 (125 Amp-rated 5 Gang). Within this meterbase we install unit main breakers ranging up to 125 Amps, example, a Square D QO2125-VH (125 Amp 2 Pole, 22K AIC, Unit Main). These "QO" breakers have a maximum wire size of 2/0 AWG. Voltage Drop on long subfeeder runs sometimes require the use of conductors larger than 2/0. We have been told that 125 Amp-rated meterbases are not UL approved for any conductors larger than 2/0 AWG. However, we can find no documentation through Square D engineers or the UL White Book that proves or disproves this statement.I understand that there are certain products such as "MAC ADAPTS" and Ilsco reducing lugs that would reduce the wire size that terminates into the unit breaker. These would be installed in the wireway section of the meterbase and would allow a 4/0 AWG SER cable to be reduced to a 2/0 AWG and terminated under the unit breaker. Another option would be to increase the meterbase size to a 225 Amp that would require breakers that accept up to 300 KCMIL conductors. However, this set-up is very costly. Is there any restrictions on the maximum size of SER cable that can be installed in these meterbases that are rated 125 Amps?We are looking for the least cost-effective design that meets the National Electrical Code.

According to the latest information from Square D and the UL White Book



125 Amp-rated meterbases (such as the EZMR115125) are


NOT UL approved for conductors larger than 2/0 AWG.Reasons

The meterbase terminals are not designed to accept conductors larger than 2/0 AWG. Oversized conductors can damage the terminals and create a safety hazard. The UL listing for the meterbase only covers specific wire sizes and configurations.

Options to Use Conductors Larger Than 2/0 AWG



Use a larger meterbase (e.g., 225 Amp) that accepts larger conductors.
However, this is a more expensive option. Use reducing lugs or adaptors (e.g., MAC ADAPTS, Ilsco reducing lugs) to reduce the conductor size down to 2/0 AWG before terminating in the unit breaker. This is a more cost-effective option, but it requires additional space in the meterbase and may impact the aesthetics.

Note

Always refer to the manufacturer's installation instructions and specifications for specific information on conductor sizes and UL approvals.* If in doubt, contact the manufacturer or a qualified electrician for guidance.

Least Cost-Effective Design:


The least cost-effective design that meets the National Electrical Code is to use reducing lugs or adaptors to reduce the conductor size to 2/0 AWG before terminating in the unit breaker. However, it is important to ensure that there is sufficient space in the meterbase for these components and that they are properly installed. Flag for review

Previous Question Next Question