Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Connection of lightening protection

User: STAR87, Location: DC area

Asked on: Tuesday, February 15, 2011 at 11:39 pm EST
Answered on: Tuesday, May 14, 2024 at 1:38 am EDT

Question: IN one of our projects i face problem now about lightening protectionthis project is a building its height 32m and its area is 3500m2the top of this building there is a canopy( decoration shape of aluminum)we now in stage of finishing and its the time to make the lightening protectioni am confused about the connection between the air terminal rodsoff course the connection will be a bare copper cable according the shop drawingthis bare cable will pass throw this canopy which its made from aluminummy question is there any problem if this bare copper cable pass throw this canopy????????some might that its forbidden to pass bare copper cable throgh any steel or aluminum and others said that its nornmal and when the lightening will occure current will pass throw the easiest wayi am confused and want definite answer

Can Bare Copper Cable Pass Through an Aluminum Canopy for Lightning Protection?Yes, it is generally acceptable to pass a bare copper cable through an aluminum canopy for lightning protection.Reasoning

Lightning seeks the path of least resistance to ground, regardless of the material of the conductor. Copper has lower resistance than aluminum, making it a more effective conductor for lightning currents. The canopy, even though made of aluminum, will not significantly impede the flow of lightning currents through the copper cable. The cross-sectional area of the cable is small compared to the canopy, and the contact between the cable and canopy is typically good enough to allow current to flow through.

Considerations

The bare copper cable should be securely attached to the lightning protection system and properly grounded. The cable should not be exposed to sharp edges or other potential damage sources that could compromise its integrity. In some cases, it may be necessary to use a protective sleeve or other insulation to prevent direct contact between the copper cable and the canopy.

Code Requirements

The National Electrical Code (NEC) does not specifically address this issue. However, it does require that lightning protection conductors be made of copper or aluminum and that they be installed in accordance with the manufacturer's instructions.

Conclusion:


Passing a bare copper cable through an aluminum canopy for lightning protection is generally acceptable and does not pose a significant safety hazard. It is important to ensure that the cable is properly installed and maintained to maximize its effectiveness. Flag for review

Previous Question Next Question