Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: TAP rules

User: petersonra, Location: Northern illinois

Asked on: Wednesday, February 16, 2011 at 12:25 pm EST
Answered on: Tuesday, May 14, 2024 at 1:39 am EDT

Question: control panel2000A mainwhat tap rules apply inside the control panel, if any.can one bring the 2000A main to a distribution block and feed from there to a small circuit - say a 15A circuit?or is there a tap rule that would prohibit this.

Tap Rules

Inside the control panel, the following tap rules apply: The size of the tap conductor cannot exceed 10% of the ampacity of the feeder conductor. The total ampacity of all taps on a feeder conductor cannot exceed 25% of the feeder conductor ampacity. The tap must be properly protected by a fuse or circuit breaker rated for the ampacity of the tap conductor.

Bringing the Main to a Distribution Block

Therefore, yes, it is permissible to bring the 2000A main to a distribution block and feed from there to a small circuit, such as a 15A circuit, provided that:
The distribution block is rated for the ampacity of the main feeder (2000A). The size of the tap conductor from the distribution block to the 15A circuit does not exceed 10% of the main feeder ampacity (200A). The tap conductor is protected by a fuse or circuit breaker rated for the tap conductor ampacity (200A).* The total ampacity of all taps on the main feeder does not exceed 25% of the main feeder ampacity (500A). Flag for review

Previous Question Next Question