Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: calculater

User: J R, Location: Ohio

Asked on: Wednesday, February 16, 2011 at 2:04 pm EST
Answered on: Tuesday, May 14, 2024 at 1:39 am EDT

Question: when replacing a tank water heater in a dwelling unit with tankless do you calculate load for service same as you would water heater or insta hot.

The load calculation for a tankless water heater is different from that of a tank water heater or an instant hot water dispenser.

Tank Water Heater and Instant Hot Water Dispenser

The load is calculated based on the wattage of the heating element and the voltage.

Tankless Water Heater

The load is calculated based on the following formula:

Load (kW) = Flow Rate (gpm) x Temperature Rise (°F) x Specific Heat of Water (Btu/lb-°F) x 0.00397
Where: Flow Rate is the maximum hot water demand in gallons per minute (gpm) Temperature Rise is the difference between the desired outlet temperature and the incoming cold water temperature in degrees Fahrenheit (°F) Specific Heat of Water is 1 Btu/lb-°F

Example

If you have a maximum hot water demand of 4 gpm and want to raise the temperature by 100°F, the load calculation would be:
Load (kW) = 4 gpm x 100°F x 1 Btu/lb-°F x 0.00397 = 1.588 kW


Note:
Tankless water heaters typically require higher electrical loads than tank water heaters because they heat water on demand. The electrical supply and wiring must be sufficient to handle the increased load. It is important to consult with a qualified electrician to determine the appropriate load and electrical requirements for your specific installation. Flag for review

Previous Question Next Question