Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Electrical conversion

User: wrogan, Location: Charlotte, NC

Asked on: Wednesday, February 16, 2011 at 3:38 pm EST
Answered on: Tuesday, May 14, 2024 at 1:40 am EDT

Question: I am having an European machine installed. The book I have calls for 3 phase 400 volts at 50/60 hz. The Tech for the company says I have to have 480 volts American. My problem is that a while back the 480 tap on my existing xformer burned out so I droped to a lower tap. My 3 phase voltage is at 456 volts. What is the American conversion of 400 volts European. My xformer is 480 delta primary and 240-120 secondary. Can I get some help with this as I am trying to save from having to buy a new xformer. Thanks Walt

American Conversion of 400 Volts European

The American conversion of 400 volts European is 480 volts, as you have already mentioned.

Compatibility with 456 Volts

Your existing 3-phase voltage of 456 volts is close to the required 480 volts. However, there are some potential issues to consider: Voltage Tolerance

Many European machines have a voltage tolerance of +/- 10%. This means that they can operate between 360 volts (400V - 10%) and 440 volts (400V + 10%).


Motor Performance

Motors operate at their rated efficiency and torque when supplied with the correct voltage. A voltage difference of 24 volts (480V - 456V) could result in slightly decreased performance.

Options


Given the voltage tolerance of European machines, you have the following options:1. Install the European machine as-is

The machine may operate without any significant issues, but it's possible that the performance will be slightly compromised.2.

Raise the transformer voltage to 480 volts

If possible, you can raise the transformer tap to provide 480 volts. However, this may require rewiring or replacing the transformer altogether.3.

Use a voltage regulator

A voltage regulator can be installed between the transformer and the European machine to boost the voltage to 480 volts.

Recommendation


If you have the ability to raise the transformer voltage to 480 volts, that would be the ideal solution. However, if that's not feasible, installing the European machine at 456 volts and monitoring its performance is an acceptable option, especially considering the voltage tolerance of European equipment. Using a voltage regulator would also be a viable solution if necessary.

Note: It's always recommended to consult with a qualified electrician or the machine manufacturer for specific advice and safety precautions. Flag for review

Previous Question Next Question