Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Arc fault or gfci on 2 wire recep

User: kbrandt, Location: arizona

Asked on: Wednesday, February 16, 2011 at 7:01 pm EST
Answered on: Tuesday, May 14, 2024 at 1:40 am EDT

Question: I have a old house that has 2 wires to receps and no grounds. Someone put 3 prong receps in and I told the owner of the rental it was not correct, he wants me to correct the problem.My question is--I know I can put a gfci recep at the first recep, but the boxes are way to small, plus the circuit splits out of a light fixture to other rooms and receps. So I what to put gfci breakers in, but I don't know if I am required to use arc fault for the bedrooms. The bedroom circuits also feed livingroom and some kitchen receps on the far wall and the lights. Only 5 20 amp circuits in this house, very small.Is it O.K. to use gfci breakers or should I use arc fault?Thanks for any help.

Electrical Code Requirements

According to the National Electrical Code (NEC), ground fault circuit interrupters (GFCIs) are required for all 120-volt receptacles installed in wet or damp locations, as well as in outdoor areas. Arc fault circuit interrupters (AFCIs) are required for all 15- and 20-amp branch circuits supplying outlets in living rooms, bedrooms, family rooms, dining rooms, and other similar areas where people may be present.

In Your Situation

Based on the NEC requirements, you should use

AFCIs
for the bedrooms and any other areas where people may be present. However, since the bedroom circuits also feed other rooms and receptacles, you can use GFCI breakers for those areas that do not require AFCIs.

Installation Considerations



Small junction boxes

If the junction boxes are too small to accommodate GFCI receptacles, you can install GFCI circuit breakers in the electrical panel instead.


Split circuits

You can install a GFCI breaker or receptacle at the point where the circuit splits out of the light fixture. This will protect all downstream receptacles on that circuit.*

Sufficient amperage

Make sure the GFCI or AFCI breakers you use are rated for the amperage of the circuit (typically 20 amps).

Recommendation

To ensure compliance with electrical code and provide adequate protection, you should install

AFCIs
for the bedroom circuits and GFCIs for any other required areas that do not require AFCIs. This will provide protection against both ground faults (GFCI) and arc faults (AFCI), which can help prevent electrical fires and injuries. Flag for review

Previous Question Next Question