User: dhalleron, Location: Louisville, KY
Asked on: Wednesday, February 16, 2011 at 9:06 pm EST
Answered on: Tuesday, May 14, 2024 at 1:41 am EDT
Question: Along with some easy stuff I am quoting a potential customer to replace some can lights. I have installed remodeler cans with new wiring, but never tried to remove old cans to install remodelers. I have 7 cans to replace from an install that might be 5 or 6 years old. How much trouble might they be?It's all finished drywall ceiling in a basement. The existing ones are too small says the owner. He wants something like a 6" can.Also he has one recessed light in an area that does not have enough light. He wanted to know if there was a trim that would convert the recessed to a surface fixture with more bulbs. I've never seen one of those. I might be able to remove the can fixture and install a box for a surface mount light.Thanks for any suggestions.
Replacing Old Can Lights with Remodelers
Difficulty
Moderate to high, especially if the existing wiring is inaccessible or the drywall is thick.
Steps
Turn off power at breaker. Remove the old can trim. Disconnect the electrical wires from the can and remove the housing from the ceiling. Check the wiring for any damage or deterioration. Install the new remodeler cans in the same location as the old ones. Connect the new cans to the wiring. Add insulation around the cans to prevent air leaks. Install the new trim rings.
Converting Recessed Light to Surface Fixture
Difficulty
Low
Options
Removable Trim Kit
Some recessed lights offer removable trim kits that allow you to convert them to surface-mounted fixtures. These kits typically have a box that mounts over the existing recessed can and provides space for additional bulbs.
Surface Mount Adapter
You can remove the recessed can entirely and install a surface mount adapter box in the ceiling. This will allow you to install a surface-mounted light fixture of your choice.
Tips: If the old wiring is not accessible, you may need to run new wire to the new cans. Use a stud finder to locate the joists before cutting into the drywall. Wear safety glasses and gloves when working with electrical wiring. If you are not comfortable with any of the steps, consult a licensed electrician. Flag for review