Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: TV equipment: AV circuits on same phase

User: malachi constant, Location: Minneapolis

Asked on: Thursday, February 17, 2011 at 10:07 am EST
Answered on: Tuesday, May 14, 2024 at 1:43 am EDT

Question: Engineer here, designing a city hall. In the council chambers the cable-access TV folk are asking for all AV equipment receptacles to be fed from same phase in same panel. it is a double-tub panel that feeds office and other areas, there is plenty other equipment fed from this panel to balance out phases.I've never had a request like this and want to make sure I'm not missing anything. These are maybe a dozen 20A/1P circuits. The only thing I can think of is the long built-in furniture where the council sits is fed from a couple conduits in the basement below. There are five circuits feeding this area, my guess is I'll have to derate them if they are all on the same phase. I'm having trouble making sense of the derating in 310 and am not entirely sure it goes into effect here, can anyone help out?Thanks!

Circuit Derating

NEC Section 310.15(B)(2) requires derating of conductors that are grouped together in a common raceway, cable, or enclosure. The derating factor is applied to the ampacity of each conductor and depends on the number of conductors and the ambient temperature.The table in 310.15(B)(2)(a) shows the derating factors for conductors in a raceway or cable with three or more current-carrying conductors. For ambient temperatures up to 30°C (86°F), the derating factor is 0.8 for three current-carrying conductors and 0.7 for four or more current-carrying conductors.

Application to Council Chambers

In this case, the five circuits feeding the council furniture are in the same raceway below the floor. If all five circuits are on the same phase and operating at their full ampacity of 20 amps, then they would need to be derated by a factor of 0.7 (assuming ambient temperature below 30°C). This means that the maximum allowable load on each circuit would be reduced to 0.7 x 20 amps = 14 amps.

Balancing Phases

To avoid derating the circuits, it is important to balance the loads across the different phases. This means that the cable-access TV equipment should be distributed evenly across the three phases of the electrical panel.

Additional Considerations Make sure that the cable-access TV equipment is compatible with the voltage and frequency of the electrical system. Provide adequate cable management to prevent cables from becoming damaged or entangled. Install surge protection devices to protect the equipment from electrical surges. Coordinate with the cable-access TV provider to ensure that they have the necessary equipment and connections. Flag for review

Previous Question Next Question