User: mwuniseal, Location: Northern illinois
Asked on: Thursday, February 17, 2011 at 1:27 pm EST
Answered on: Tuesday, May 14, 2024 at 1:43 am EDT
Question: We have a dart digital speed pot with a lenze vfd that is giving us problems. At least once a month the digital speed pot is failing. The incoming supply is 480 3 phase. We have a 1 kva 480 to 120 transformer to supply control voltage. The drive, transformer,and speed pot are all in one cabinet. After the digital drive fails, we remove all voltage to cabinet, after several hours we reapply voltage and everything works fine. We believe the speed pot is failing due to noise off of the drive.
Potential Causes of Digital Speed Pot Failure and Troubleshooting Steps
1. Electrical Noise from VFD
Install a line filter
This device can help suppress high-frequency noise from the VFD that may be affecting the speed pot.
Ground the VFD and speed pot
Ensure that both devices are properly grounded to minimize noise.
Check for loose connections
Inspect the wiring connections between the VFD, transformer, and speed pot for any loose or damaged wires.
2. Overvoltage or Spikes
Use a voltage regulator
This device can help stabilize the voltage supply to the speed pot.
Install surge protectors
This can protect the speed pot from sudden voltage surges.
3. Heat and Ventilation
Ensure proper ventilation
The cabinet should have adequate ventilation to dissipate heat from the VFD and other components.
Install a fan
Consider adding a fan to the cabinet to improve airflow.
4. Other Factors
Check for moisture
Dampness in the cabinet can affect the speed pot.
Inspect the speed pot contacts
Ensure that the contacts are not worn or damaged.
Update firmware
Check if there is an updated firmware available for the speed pot or VFD.
Troubleshooting Procedure
1. Remove all voltage from the cabinet.
2. Wait several hours for noise and voltage to dissipate.3. Reapply voltage and observe the behavior of the speed pot.
4. If the speed pot still fails, follow the troubleshooting steps outlined above.5. If the speed pot continues to fail, consider contacting the manufacturer for technical support.
Additional Tips: Use a dedicated control transformer to isolate the control voltage from the power supply. Install a noise filter on the VFD output. Consider using a shielded cable for the speed pot connection. Implement a regular maintenance schedule to inspect and clean the cabinet and components. Flag for review