Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: 3ph 4wire Y connected system losing phase

User: Designer69, Location: Logan, Utah

Asked on: Thursday, February 17, 2011 at 3:12 pm EST
Answered on: Tuesday, May 14, 2024 at 1:44 am EDT

Question: gents,good afternoon. We have a 3ph 4wire Y connected system that repeatedly loses a phase and the other 2 phases continue to operate without the OCPD tripping out the circuit.is this crazy? this should not be happening should it?thanks

This is indeed an abnormal and potentially dangerous situation. In a 3-phase, 4-wire, Y-connected system, the loss of one phase should cause the overcurrent protection device (OCPD) to trip and isolate the circuit, as the unbalanced currents can damage equipment and pose safety hazards.There are several possible reasons why the OCPD is not tripping in this case: Incorrect OCPD Size

The OCPD may be oversized for the circuit, allowing excessive current to flow without tripping.


Defective OCPD

The OCPD itself may be faulty or damaged, preventing it from tripping properly.

Neutral Connection Issue

If the neutral connection is loose or broken, it can cause the OCPD to sense an imbalance but not trip.


Load Imbalance

An extreme imbalance in load currents could potentially prevent the OCPD from tripping, but this is unlikely in a balanced system.*

Other Electrical Faults

An electrical fault or wiring issue elsewhere in the circuit could be preventing the OCPD from detecting the phase loss.It is crucial to investigate and address this issue immediately. The following steps are recommended:1.

Verify the System Ground

Ensure the system ground is properly bonded and connected to the neutral bus.2.

Check the OCPD

Inspect the OCPD for proper size and condition. If necessary, replace the OCPD.3.

Examine the Neutral Connection

Tighten and inspect all neutral connections.4.

Test the System

Use a voltmeter or multimeter to measure the voltage on each phase. If one phase is missing, isolate the circuit and track down the source of the issue.5.

Consult an Electrician:
If you are unable to resolve the issue, contact a qualified electrician to assist with further troubleshooting and repair.Ignoring this problem can lead to further damage to equipment, potential fire hazards, and safety concerns. Take immediate action to rectify the situation and ensure the safe operation of your electrical system. Flag for review

Previous Question Next Question