Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Mobile Homes

User: Devin A. Pratt, Location: Upstate New York

Asked on: Friday, February 18, 2011 at 10:49 am EST
Answered on: Tuesday, May 14, 2024 at 1:46 am EDT

Question: Who is responsible for rough in inspecting mobile homes when manufactured?Are the following findings common for these homes?Recently I was called for power loss at a double wide mobile come set in on a 2 foot foundation/crawl space. This home is approx two hours from my home base the HO had three electricians attempt to trouble shoot their problems with no success.This home has four bedrooms, 2 baths, 2 living rooms, office, dining room, Kitchen and utiliy room.Panel 12 space cutler hammerFindings:15amp OCPD 14/2 NMB wire Feeding.9 outlets including the Master Bed, Master Bath GFCI,Living Room, Utility Room and Heat Tape Outlet under home in crawl space.7 Areas of lighting Master Bed 1 light, Master Bath 2 lights and 2 fans, Master Closet 1 light, Utiliy 1 light, 1 coach light and kitchen 1 light.Problems Found Other than overloaded circuitry.Open nuetral in the outlet under the home and pin hole in the insulation of positive conductor touching the ground in the switch for the master bed light.None of the devices on the circuit were properly terminated.

Responsibility for Rough-In Inspection

The responsibility for rough-in inspection of mobile homes varies depending on local regulations and the manufacturer's practices. In general, it is the responsibility of the: Manufactured Home Inspector (MHI): In many jurisdictions, MHIs are responsible for inspecting the electrical rough-in during the manufacturing process. Local Building Inspector: In some areas, the local building inspector may also perform a rough-in inspection. Manufacturer: The manufacturer may have its own quality control process that includes rough-in inspections.

Common Findings in Mobile Homes

The following findings are common in mobile homes:
Overloaded circuitry: This occurs when too many appliances or devices are connected to a single circuit, exceeding its capacity. Improper termination of devices: Devices may not be properly secured or connected to the electrical system, leading to loose connections and potential arcs. Damaged wiring: Insulation damage, loose connections, or improper wiring can cause electrical hazards. Open neutrals: A break in the neutral conductor can cause voltage imbalances and other electrical problems. Missing ground connections: Improper grounding can create shock hazards and damage electrical equipment.

Additional Findings in the Mentioned Home

In the case of the double wide mobile home mentioned, the following additional findings were identified: 15 amp OCPD on a 14/2 NMB wire feeder: This is a code violation, as the OCPD should match the wire size rating. Open neutral and pin hole insulation in switch: These are serious electrical hazards that require immediate attention.* Improper termination of devices: This is a common issue that can lead to loose connections and potential arcs. Flag for review

Previous Question Next Question