Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: 110vac 1phs motor.

User: kda3310, Location: Dry Prong, Louisiana

Asked on: Saturday, February 19, 2011 at 11:59 am EST
Answered on: Tuesday, May 14, 2024 at 1:48 am EDT

Question: I have a 1ph 110v motor on my hot tub with three wires coming out marked Hi, line, and Low. The motor is grounded out and the replacement motors leads are not marked the same. The new motors leads are marked 2, 3, and 4. Wich number is Hi, Line, and Low?

Step 1: Identify the Common (Line) Wire The "line" wire is the one that is connected to the hot side of the power supply. Using a multimeter set to the continuity setting, test between Hi, Line, and Low. The wire that shows continuity with both Hi and Low is the "line" wire.

Step 2: Determine the Hi and Low Wires
Once the common (line) wire is identified, you can determine the Hi and Low wires by testing the resistance between the common wire and each of the remaining wires. The wire with the higher resistance (typically around 5-10 ohms) is the "Hi" wire. The wire with the lower resistance (typically around 2-5 ohms) is the "Low" wire.

Connection

Connect the "Hi" wire of the new motor to the "Hi" wire of the hot tub. Connect the "Line" wire of the new motor to the "Line" wire of the hot tub. Connect the "Low" wire of the new motor to the "Low" wire of the hot tub.

Note:
If the multimeter test does not yield clear results, you can also consult the wiring diagram for the hot tub or motor manufacturer for more detailed instructions.* Double-check all connections before turning on the power to ensure proper operation. Flag for review

Previous Question Next Question