User: boltneck, Location: Raeford, NC
Asked on: Saturday, February 19, 2011 at 6:31 pm EST
Answered on: Tuesday, May 14, 2024 at 1:48 am EDT
Question: I have a customer that wants a gen install that has me questioning the best way to accomplish this200 amp main panel and 100 amp sub panel to a detached garagegarage panel has a 3 wire feeder from the main panelcustomer wants to control whole house, havent did a load calc yet but dont think this will be a problem with the mid size gen set he is looking at, as the house has oil heatwhat has me confused is this, with a service rated transfer switch, the main panel will then become a sub panel with the neutrals and grounds seperate, correct?can this be done correctly using the existing feeder to the garage, or will the garage feeder and also the range and dryer 3 wire ckts need to be changed to 4 wire since they now will originate in a sub paneli need to incorporate the garage panel into the generator because the well pump as well as 2 freezers are fed from the garage panel
Using the Existing Feeder to the Garage
Yes, you can use the existing 3-wire feeder to the garage with the following considerations: The feeder must be rated for the generator's amperage. The garage panel must be converted to a subpanel by separating the neutrals and grounds. The feeder from the generator to the main panel must be 4-wire (including a neutral and ground).
Circuit Modification
Since the range and dryer circuits will now originate in the garage subpanel, they will need to be modified to 4-wire configurations. This involves adding a neutral wire to these circuits.
Incorporating Garage Panel into Generator
To incorporate the garage panel into the generator system, follow these steps:1. Install a service-rated transfer switch at the main panel.
2. Connect the generator's output to the transfer switch.3. Connect the main panel's main breaker to the transfer switch.
4. Convert the garage panel to a subpanel and connect it to the transfer switch.5. Modify the range and dryer circuits to 4-wire configurations.
6. Interconnect the neutrals and grounds at the transfer switch.
Grounding Considerations
The generator must be properly grounded according to the manufacturer's instructions. The transfer switch should have a neutral bonding screw that connects the generator's neutral to the neutral busbar. The ground busbar in the main panel and garage subpanel should be bonded to the grounding electrode system.
Additional Notes: It is recommended to perform a load calculation to determine the size of generator required. It is important to follow all applicable electrical codes and manufacturer's guidelines.* Consider installing surge protection devices to protect the generator and connected equipment. Flag for review