User: brantmacga, Location: Georgia
Asked on: Saturday, February 19, 2011 at 9:44 pm EST
Answered on: Tuesday, May 14, 2024 at 1:48 am EDT
Question: had a call about a reversible motor not working.only had a few min to look at it, but what i found is that i had 120v on both motor leads.discharged and checked capacitor; reading was normal.disconnected motor from control board and manually opened/closed relays, and found the board to be sending voltage to the correct terminals for each direction.so the backfeed is coming from inside the motor.what causes this?thanks
Possible Causes of Backfeed in Reversible Motors
Short-circuited stator windings
If one or more of the stator windings has become shorted, it can create a path for current to flow back through the motor, causing backfeed.
Rotor damage
Damage to the rotor, such as broken or loose bars, can cause imbalances in the magnetic field, leading to backfeed.
Failed insulation
Deterioration or damage to the insulation between the windings or the rotor and stator can allow current to leak across and create backfeed.
Loose or oxidized connections
Loose or oxidized connections between the motor leads and terminals can create high resistance, which can cause backfeed by allowing current to flow more easily in one direction than the other.
Residual magnetism
In some cases, the motor's magnetic field can become "trapped" in the stator or rotor, causing a residual voltage that can lead to backfeed.
Faulty control board
While you mentioned that the control board appears to be sending voltage correctly, it's still possible that a malfunctioning component (e.g., relay) could contribute to backfeed.
Troubleshooting Steps:
To determine the exact cause of backfeed, you may need to perform additional troubleshooting steps: Use a megger or insulation tester to check for shorts and insulation breakdown in the motor windings. Inspect the rotor for any visible damage or loose bars. Clean and tighten all connections between the motor and control board. If possible, disconnect the motor from the control board and supply it with a known voltage from another source (e.g., a variable frequency drive) to see if the backfeed persists. Flag for review