User: john26, Location: Chapel Hill, NC
Asked on: Sunday, February 20, 2011 at 1:11 pm EST
Answered on: Tuesday, May 14, 2024 at 1:49 am EDT
Question: I know that with line voltage , a raised cover on an electrical box should be flush to 1/4 inch behind rock. Wanted to know ? if using standard 1900 box with raised cover thats falls 1/2 inch shy of sheet is ok for low voltage as in 24 volts. If so how do show proof to general contractor that its not a code violation .
Yes, it is generally acceptable to have a raised cover on an electrical box that falls 1/2 inch shy of the sheetrock for low voltage applications (24 volts or less).Code Requirements
The National Electrical Code (NEC) does not specifically address the protrusion of low voltage electrical box covers, as it is not considered a safety hazard. However, for line voltage (120V or higher), Section 314.20(A) of the NEC requires that raised covers be flush with or within 1/4 inch of the finished surface.
Justification for Low Voltage Exception
Low voltage is not considered a shock hazard, so the same level of protection is not necessary. The raised cover provides additional protection against moisture and dust. It is common practice in the industry to use raised covers for low voltage applications.
Showing Proof to General Contractor
To show proof to the general contractor that it is not a code violation, you can:
Refer to the NEC
Explain that Section 314.20(A) does not apply to low voltage applications.
Provide Industry Standards
Cite reputable sources such as the National Electrical Contractors Association (NECA) or the Electrical Safety Foundation International (ESFI) that support the use of raised covers for low voltage.
Show Precedents
Present examples of similar projects where raised covers were used and accepted by inspectors.*
Explain the Benefits
Discuss the advantages of using raised covers for low voltage, such as enhanced protection and improved aesthetics.
Note: It is always best to consult with the local electrical inspector for specific approval before installing any electrical equipment. Some jurisdictions may have additional requirements or interpretations regarding low voltage applications. Flag for review