User: czars, Location: West Melbourne, FL
Asked on: Sunday, February 20, 2011 at 2:33 pm EST
Answered on: Tuesday, May 14, 2024 at 1:49 am EDT
Question: 2008 NEC, Article 310.11 states that "All conductors and cables shall be marked ---". This statement implies that the conductors within cables are required to be marked. However, the conductors of many cables (NM-B, SER, etc.) are not marked, but the outer cable covering is properly marked. Are there other code articles that permit the conductors within cables be to unmarked? If not, how do we deal with the first sentence of 310.11?
NEC Article 310.11 does not require individual conductors within cables to be marked.
The first sentence of Article 310.11 states: "All conductors and cables shall be marked...." However, this statement does not imply that the conductors within cables must be marked. The conductors within cables are typically not marked, and the outer cable covering is properly marked instead.
This interpretation is supported by the following code articles
NEC Article 110.3(B) states that "The provisions of this Code do not apply to conductors that are contained within recognized raceways, auxiliary gutters, enclosures, or other recognized enclosures." This means that the requirements of Article 310.11 do not apply to conductors that are within cables, as cables are considered to be recognized enclosures. NEC Article 310.12(B) states that "Conductors of different systems, circuits, or voltage shall be permitted to be contained within the same cable, enclosure, or raceway provided all conductors are insulated for the maximum voltage of any conductor within the enclosure, raceway, or cable." This means that conductors of different circuits can be contained within the same cable, even if the conductors are not marked.
Therefore, we can conclude that the following conductors do not need to be marked: Conductors within cables Conductors of different systems, circuits, or voltage that are contained within the same cableThis interpretation is also consistent with the intent of Article 310.11, which is to ensure that all conductors are properly identified so that they can be installed and maintained safely. The outer cable covering of a cable provides sufficient identification for the conductors within the cable, so there is no need for the individual conductors to be marked. Flag for review