User: faresos, Location: Chapel Hill, NC
Asked on: Monday, February 21, 2011 at 1:47 pm EST
Answered on: Tuesday, May 14, 2024 at 1:51 am EDT
Question: I'm working a project that they want to build a modular building (similar to trailer type) on an existing concrete pad. The building is raised 3ft of the pad and is much smaller than the pad. We are providing a lightning system to this building. My question is, do I need to provide a ground ring around the pad even though the pad is much smaller than the building? For some reason, I thought if it was an existing structure then the ground ring is not required. If it was required, any preferred method on how to install it? Is there any special requirement for the grounding system?Thanks in advance.
Ground Ring Requirement
As per the National Electrical Code (NEC), a grounding ring is required for any structure containing electrical equipment or systems, regardless of its size or whether it is new or existing.
For Isolated Concrete Pad
Even though the concrete pad is smaller than the building, it is still considered an electrically isolated structure and requires a grounding ring. The grounding ring will provide a path to ground for any fault currents or lightning strikes.
Preferred Method of Ground Ring Installation
1.
Buried Ground Ring
Install a bare copper conductor (minimum #6 AWG) around the perimeter of the concrete pad, buried at least 12" deep in the soil. Connect the ends of the conductor together to form a complete loop.2.
Above-Ground Ground Ring
If burying the ground ring is not feasible, install it above ground using non-metallic conduit or other approved methods. The ring should be elevated at least 6" above the ground and supported by stakes or brackets.
Special Requirements for Grounding System
The grounding ring conductor must be a bare copper conductor (no insulation). The ground rod must be a minimum of 8' long and driven into moist soil. The ground rod must be connected to the grounding ring using a copper conductor (minimum #6 AWG) and a grounding clamp. The resistance of the grounding system (ground ring and rod) should be less than 25 ohms.
Additional Considerations: If the building is located in an area with high lightning activity, additional lightning protection measures may be required, such as lightning rods or mesh. Consult with a licensed electrician or the local building department for specific requirements and approvals. Flag for review