User: Ravenvalor, Location: Piedmont region of NC
Asked on: Tuesday, February 22, 2011 at 9:15 am EST
Answered on: Tuesday, May 14, 2024 at 1:53 am EDT
Question: A 5 - year old home has a lighting and receptacle circuit tripping a circuit breaker. The breaker is 15amp and not an arc-fault. Since it is only doing it once daily I would like to find or develop some machine that will locate the assuming short. When I get to the home it will not be tripping therefore I need to find a short that is not occuring in my presence.I am an electrical contractor who has been fixing these types of problems for 24 years. Usually I have to check every accessible part of the circuit including the appliances. I am wondering if there is a theorem associated with ohm's law that will enable me to calculate varying voltages and amps at each outlet to reveal the short.Thanks,Jim
Ohm's Law Theorem
Ohm's law states that the current (I) flowing through a conductor between two points is directly proportional to the voltage (V) across the two points and inversely proportional to the resistance (R) between them.
I = V / RMeasurement Technique
To use Ohm's law to locate a short circuit, follow these steps:1. Measure Voltage and Current
Use a multimeter to measure the voltage (V) and current (I) at each outlet on the circuit. Record the values.2.
Calculate Resistance
For each outlet, calculate the resistance (R) using Ohm's law:
3. R = V / I
Compare Resistances
The outlet with the lowest resistance indicates the location of the short circuit.
Determining Short Circuit
The lowest resistance will correspond to the location of the short circuit because: A short circuit reduces the resistance of a circuit. A lower resistance allows more current to flow through the circuit. This increased current causes the circuit breaker to trip.
Cautions Ensure the circuit is de-energized before performing any measurements. Use caution when working with electrical circuits. This technique may not locate all types of short circuits, especially those involving intermittent or arcing faults. Always consider other factors such as loose connections, damaged wires, or malfunctioning appliances.
Additional Notes This technique can be time-consuming, especially for large circuits. Consider using specialized equipment such as a time-domain reflectometer (TDR) or a cable tester to locate the short more accurately. If the short circuit cannot be located, consider consulting with a qualified electrician for further assistance. Flag for review