Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Water heaters and cord/plug/receptacle disconnect.

User: Strife, Location: Tampa Florida

Asked on: Tuesday, February 22, 2011 at 6:39 pm EST
Answered on: Tuesday, May 14, 2024 at 1:54 am EDT

Question: Been doing some remodels lately and in two different cities the inspector asked me to change the existing cord/plug/receptacle to the water heater with switch and flex.As it's no big deal, and the owner's paying for it I didn't want to irk the inspector, but I'm curious, what part of NEC prohibits that? It has to be a change in last 30 years or so, as this is pretty prevalent in a lot of 30 some YO homes.And the water heater wasn't even part of the remodeling.I always thought plug and receptacle it's a means of disconnect.

Section 422.16(B) of the National Electrical Code (NEC) prohibits the use of cords, plugs, and receptacles as a means of disconnecting water heaters.

Reason

Water heaters draw high currents and generate heat, which can pose a safety hazard if the cord or plug is not properly rated or installed. The NEC requires a permanently installed disconnect switch or circuit breaker to be used instead.

Exception

The NEC allows the use of cords, plugs, and receptacles for water heaters rated at 120 volts, 15 amps, or less. However, this is not applicable to the majority of water heaters.

Implications for Older Homes

Many older homes may have water heaters connected with cords and plugs. While this may have been permissible at the time of installation, it is no longer compliant with the current NEC. Inspectors will typically require these connections to be replaced with a properly installed disconnect switch or circuit breaker.

Note:
The NEC is periodically revised, and the specific requirements may vary depending on the edition being enforced in your area. It's always best to consult with a qualified electrician or local code enforcement official for the most up-to-date requirements. Flag for review

Previous Question Next Question