Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Circuit Tracker

User: Little Bill, Location: Tennessee NEC:2017

Asked on: Tuesday, February 22, 2011 at 7:27 pm EST
Answered on: Tuesday, May 14, 2024 at 1:55 am EDT

Question: I have a GB Instruments Circuit Tracker GET-1200 that I have had for a few years. I've only used it a couple of times, and then in a single phase panel. Today I needed to trace some receps/circuits so I got the Circuit Tracker out to try and find them. The panel that the circuits are in is a 3pf 208/120V. This tracker has a visible scale (green-red) and an audible alarm when you find the right breaker. The problem I was having was I got full scale readings on several breakers, which was useless to me. You could hear what sounded like a 60HZ hum or buzz on most every breaker. The audible alarm is a chirping sound, which I could hear in more than one place. I would hold it in one place for several seconds thinking that was the strongest signal only to find if you checked again, it had moved. I just gave up on trying with this thing. I couldn't flip the breakers because the receps. were being used. The only thing I can think of is there were apparently some MWBC in there and several non linear loads on some circuits, thus giving me a lot of trash and false readings. Any thoughts on this?

Possible Causes of False Readings



Multiple Parallel Circuits

If multiple circuits share the same neutral (common in MWBCs), current flow in one circuit can induce false readings in parallel circuits due to electromagnetic coupling.


Non-Linear Loads

Electronic devices with non-linear current draw (e.g., LED lights, computers) can generate harmonics that interfere with the tracker's readings.

Background Noise

Electrical noise from motors, transformers, or other equipment can mimic the tracker's signal.


Faulty Tracker

The tracker itself could be malfunctioning or improperly calibrated.

Troubleshooting Tips



Use a Different Phase

If possible, try using the tracker on a different phase to see if the problem persists.


Check the Neutral

Ensure that the tracker's neutral probe is properly connected to a neutral conductor.

Minimize Electrical Interference

Turn off nearby equipment or move the tracker away from potential noise sources.


Try a Different Tracker

Consider borrowing or renting a different circuit tracker to see if the issue is with your device.

Contact the Manufacturer

Reach out to GB Instruments for technical support or to check for any known issues with the GET-1200 model.

Possible Solutions



Filter for Harmonics

Use a circuit tracker with built-in harmonic filters to mitigate false readings from non-linear loads.

Use a Clamp Meter

Consider using a clamp meter to measure current flow on individual circuits, which is less susceptible to interference.


Trace Cables Manually

If other methods fail, manually trace cables from the panel to the receptables using a tone generator and probe.*

Consider Professional Help:
If you are unable to resolve the issue, consider hiring a qualified electrician to assist with circuit tracing. Flag for review

Previous Question Next Question