Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: 690.64 solar grid tie in

User: highvolts582, Location: brick nj

Asked on: Tuesday, February 22, 2011 at 8:55 pm EST
Answered on: Tuesday, May 14, 2024 at 1:55 am EDT

Question: My question is regarding 690.64 I understand the concept of this calculation concerning putting breakers in the house panel or doing a line side tap if the calculation works out over the rating of the bus bar in the branch circuit main panel. My question is does my AC combiner panel also have to be sized the same way. so if i have two 30 amp breakers and 60 main in a 125 amp combiner panel do I have to up the size to 150 or can I leave the 125 amp combiner panel the same as long as i do a Line side tap to feed this panel.Thanksguys

Electrical Panel Sizing

The sizing of electrical panels, including AC combiner panels, follows similar principles as those for branch circuit panels. The purpose of these calculations is to ensure that the current-carrying capacity of the panel components is not exceeded.

Panel Bus Rating

The bus rating of a panel refers to the maximum current it can safely carry. This rating is typically higher than the sum of the breaker ratings to account for potential overloads and future expansion.

Branch Circuit Panel

In a branch circuit panel, the calculation 690.64 is used to determine if a line-side tap is required. If the sum of the breaker ratings exceeds the bus rating, a line-side tap must be installed to feed the panel from a higher capacity circuit.

AC Combiner Panel

The same principle applies to AC combiner panels. The sum of the breaker ratings within the combiner panel should not exceed the panel's bus rating. If the rating is exceeded, a line-side tap or a larger combiner panel is required.

Your Question

In your specific case, with two 30 amp breakers and a 60 amp main in a 125 amp combiner panel: If you do not perform a line-side tap: The sum of the breaker ratings (90 amps) exceeds the bus rating of the panel (125 amps). Therefore, you would have to upgrade to a 150 amp combiner panel for safety. If you do perform a line-side tap: The current is bypassed around the panel's bus, so the bus rating is not exceeded. You can keep the 125 amp combiner panel.

Conclusion

Whether or not you need to upgrade your AC combiner panel depends on whether you perform a line-side tap and the specific current demands of your system. Always consult with a qualified electrician to ensure that the panel and its components are properly sized and installed for safety. Flag for review

Previous Question Next Question