Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: three phase motor unbalance on amps

User: cmtskx500, Location: wyoming

Asked on: Tuesday, February 22, 2011 at 9:34 pm EST
Answered on: Tuesday, May 14, 2024 at 1:55 am EDT

Question: at work we have a 400hp 480 volt three phase motor that draws 439 amps on A phase, 398 on B phase, and 329 on C phase. the primary voltage is 14400 stepped down through a Y Y connected set of 500 kva cans we have replaced all the connections. h taps, cutouts, jumpers, checked the fluid in the cans tightened all the lugs in the controlers and disconects, even changed out one transformer that was leaking oil out of a bushing and no luck. we took a buckett truck down the line to the substation and no loose or bad conections. any suggestions?

Troubleshooting Steps



1. Verify Electrical Parameters

Confirm the motor specifications, including voltage, amperage, and horsepower. Measure the voltage and amperage at the motor terminals to ensure correlation with the anticipated values. Check the power factor of the motor to rule out any reactive power issues.

2. Inspect Transformer Connections

Verify the proper connection of the motor leads to the transformer terminals on the secondary side. Ensure correct polarity and phase sequence of the transformer windings. Check the tightness and cleanliness of all electrical connections, including taps, jumpers, and lugs.

3. Examine Primary Circuit

Check the incoming voltage at the primary side of the transformer. Inspect the primary circuit for any loose connections or open circuits. Verify the tap settings of the transformer to ensure they are correctly adjusted.

4. Analyze Motor Load

Examine the mechanical load on the motor to determine if there is any excessive or unbalanced load causing the motor to draw uneven amperage. Consider the possibility of a jammed bearing or mechanical friction.

5. Measure Insulation Resistance

Conduct insulation resistance testing on the motor windings and transformer windings to identify any insulation breakdown.

6. Inspect Switchgear

Check the disconnect switches for any loose or damaged contacts. Verify the functionality of the motor controller, including any overload relays or protection devices.

7. Consider Harmonics

Perform harmonic analysis on the electrical system to determine if there is any significant harmonic distortion, which could affect the motor performance.

Possible Causes and Solutions



Loose connections

Tighten or repair any loose electrical connections.

Transformer damage

Replace any damaged or leaking transformers.


Incorrect transformer taps

Adjust the transformer taps to the correct voltage.

Motor overload

Reduce the load on the motor or inspect the mechanical system for binding.


Electrical noise

Install harmonic filters to mitigate any harmonics in the system.

Open circuit in motor windings

Repair or replace the affected windings.


Motor bearing issues:
Lubricate or replace the bearings to reduce friction. Flag for review

Previous Question Next Question