User: VIC1958, Location: Chapel Hill, NC
Asked on: Wednesday, February 23, 2011 at 12:59 pm EST
Answered on: Tuesday, May 14, 2024 at 1:57 am EDT
Question: The electric meter is located on the utility pole which is probably 75' from the house. Over head service to house to service mast then into panel board. There is no grounding rod outside the house for the panel board, there is no grounding rod located at the meter. There is a grounding conductor running down the side of the pole into the ground servicing the coductors on the pole. Water service inside the house is also not grounded/bonded to the panel. Where should the grounding rod be located for this type of situation? This is in an older section of town and I beleive this is a isolated situation.
Grounding Rod Location
The grounding rod should be installed as close as possible to the service mast, where the overhead service enters the house. This ensures a low impedance path for fault currents to return to the ground.
Grounding Conductor
A bare copper grounding conductor should be used to connect the grounding rod to the service mast. The conductor should be at least #6 AWG and run through a grounding electrode conductor. The grounding conductor should be connected to the service mast using a listed grounding clamp.
Grounding Wire
A separate grounding wire should be run from the service mast to the panel board. This wire should be sized according to the electrical code requirements for the circuit conductors. The grounding wire should be connected to the ground busbar in the panel board.
Water Service Grounding
The water service pipe should be bonded to the grounding rod or grounding conductor near the point of entry into the house. This provides an additional path for fault currents to return to the ground. A bare copper grounding conductor should be used for the bonding connection.
Additional Considerations: If there is no existing grounding rod at the meter, the utility may need to install one. If the grounding rod cannot be located near the service mast due to physical constraints, it can be installed at another suitable location, such as near the foundation of the house. The grounding system should be tested for proper operation using an approved grounding resistance tester. Flag for review