Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: spdt or 3 way switch?

User: lowvoltman, Location: Ca and Wa

Asked on: Wednesday, February 23, 2011 at 3:39 pm EST
Answered on: Tuesday, May 14, 2024 at 1:58 am EDT

Question: I was thinking of using a spdt toggle switch as a simple change over or transfer switch. could you use 2 generators with 120v each to feed 1 load. using the switch to switch between generators? could you tie the neutrals together?what do ya'll think?

Using a SPDT Toggle Switch as a Changeover Switch

Yes, you can use a SPDT (Single Pole, Double Throw) toggle switch as a simple changeover switch to feed a load from two 120V generators. The switch will allow you to select between Generator 1 or Generator 2 to provide power to the load.

Wiring Diagram

Generator 1           Generator 2________             ________|        |           |        
| | |Live1-| 1 |-COM------| 2 |-Live2|________| |________
Neutral | | Neutral |
Steps

1. Connect the live wire (hot wire) from Generator 1 to terminal 1 of the switch.
2. Connect the live wire from Generator 2 to terminal 2 of the switch.3. Connect the common (COM) terminal of the switch to the live wire of the load.
4. Connect the neutral wires from both generators and the load together.


Tying the Neutrals Together


Yes, it is important to tie the neutral wires from both generators and the load together. This ensures that all three components are at the same electrical potential and prevents any voltage differences that could damage equipment.

Safety Considerations Ensure that the generators are properly grounded. Use proper wire gauge and connections to handle the load current. Place the switch in a convenient and accessible location. Label the switch clearly to indicate which generator is selected.

Note: This setup assumes that the generators are in phase. If they are not in phase, you may need to use a phase-correcting transformer or consider other options for transferring power between generators. It is always advisable to consult with a qualified electrician for proper installation and safety precautions. Flag for review

Previous Question Next Question