Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Metal roof penetration

User: chattahoochee electrical, Location: Minnesota

Asked on: Wednesday, February 23, 2011 at 6:09 pm EST
Answered on: Tuesday, May 14, 2024 at 1:58 am EDT

Question: I am bidding a 200 amp. service on a home with a metal roof. I need some input on sealing around the 2 in. mast. Do I use a roof boot or is there another option?

Roof Boot

Using a roof boot is the most common and recommended option for sealing around a 2-inch mast on a metal roof. Benefits

Provides a watertight seal around the mast Prevents moisture from entering the roof cavity Allows for thermal expansion and contraction of the mast Available in various sizes and materials to match the roof

Installation

Cut a hole in the metal roof large enough to accommodate the base of the roof boot. Clean the area around the hole. Apply a bead of silicone caulk around the base of the roof boot. Slide the roof boot over the mast and into the hole. Secure the boot to the roof with screws or nails. Apply a second bead of caulk around the perimeter of the roof boot.

Alternative Option: Metal Pipe Flashing


An alternative option to using a roof boot is to install a metal pipe flashing:
Materials

Metal pipe flashing (available in various diameters) Silicone caulk

Installation

Cut the pipe flashing to a length that extends at least 4 inches above and 4 inches below the roof surface. Slip the pipe flashing over the mast. Apply a bead of silicone caulk around the bottom edge of the flashing. Insert the flashing into the hole cut in the metal roof. Secure the flashing to the roof with screws or nails. Apply a second bead of caulk around the perimeter of the flashing.

Considerations

The metal pipe flashing method is less expensive than using a roof boot. However, it may not provide as watertight a seal, especially in areas with heavy rainfall. It is crucial to ensure that the flashing is properly installed and sealed to prevent leaks.

Recommendation:


For best results, it is recommended to use a roof boot specifically designed for metal roofs. This provides a reliable and watertight seal that will protect the roof and electrical system from moisture damage. Flag for review

Previous Question Next Question