Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Main Lug or Main Breaker Panels?

User: stevet, Location: New York

Asked on: Thursday, February 24, 2011 at 10:16 am EST
Answered on: Tuesday, May 14, 2024 at 1:59 am EDT

Question: Hello,I have allways installed sub-panels with a Main Breaker in it. I see a lot of main lug panels out there (as sub panels)Are there any limitations where you cannot use the main lug panels? Distance of run a factor? Can a Main Lug be installed anywhere? I know that a main breaker is needed after a transformer, or Main panel.Thanks - Good DaySJT

Limitations of Using Main Lug Sub-Panels



No Main Circuit Breaker

Main lug sub-panels do not have a built-in main circuit breaker, which means they do not provide branch circuit protection.


Necessitates a Main Breaker Upstream

A main breaker must be installed upstream of the main lug sub-panel, typically in the main service panel.

Voltage Limitations

Main lug sub-panels are typically rated for lower voltages (e.g., 120/240V) than main breaker sub-panels.


Distance Limitations

The distance between the main breaker and the main lug sub-panel should comply with the National Electrical Code (NEC) requirements, which vary depending on the circuit amperage.

When Main Lug Panels Cannot Be Used

Where the sub-panel is the first panel after the utility connection or transformer. Where a main circuit breaker is required for safety or code compliance, such as in mobile homes or recreational vehicles. Where branch circuit protection is needed directly within the sub-panel, such as in workshops or garages.

Where Main Lug Panels Can Be Installed

As sub-panels in residential or commercial buildings where the main breaker is located in the main service panel. In small applications where branch circuit protection is not needed at the sub-panel location. In temporary or portable installations where a main breaker is not required.

Additional Considerations:
Main lug sub-panels require an additional cost for the separate main breaker, which is not included in the panel itself. Main breaker sub-panels offer greater flexibility and control over branch circuit protection.* Always consult the NEC and local building codes for specific requirements regarding the installation of sub-panels. Flag for review

Previous Question Next Question