Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Exhaust fan switching

User: bbuckway, Location: Torrington, CT

Asked on: Thursday, February 24, 2011 at 12:00 pm EST
Answered on: Tuesday, May 14, 2024 at 1:59 am EDT

Question: I have 1 exhaust fan exhausting 3 rooms that need to be controlled separately . I know how to do this with motion sensors but is it against code to install with 1 pole toggle switches on a 120 volt system with out any relays? This would cause a backfeed on the switchlegs of 2 of the switches after 1 switch was turned on.

Yes, it is against the NEC (National Electrical Code) to install exhaust fans with 1-pole toggle switches on a 120-volt system without relays when multiple fans share a single exhaust duct. Here's why

Backfeeding:

When one switch is turned on, power flows through the shared exhaust duct to the other switches. This creates a "backfeed" condition, where voltage is present on the switchlegs of the unused switches even when they are turned off.

Safety Hazard

Backfeeding poses a safety hazard because it can energize the switchplates of the unused switches, creating a risk of electrical shock if someone touches them.

Overloading

The shared exhaust duct can become overloaded if multiple fans are turned on simultaneously. This can cause overheating and damage to the fans and/or the electrical system.

To comply with the NEC, the correct way to control multiple exhaust fans sharing a single exhaust duct is to use a relay



Relay

A relay is an electrical device that uses a low-voltage control circuit to switch a higher-voltage circuit.


Separate Switchlegs

Each exhaust fan should have its own separate switchleg, so that when one switch is turned on, power only flows to that fan.*

Control Circuit:
A low-voltage control circuit is wired to the toggle switches. When a switch is turned on, it sends a signal to the relay, which then closes the higher-voltage circuit to power the corresponding fan.This configuration ensures that there is no backfeed and that the fans can be controlled independently without overloading the exhaust duct. Flag for review

Previous Question Next Question