User: Jraef, Location: San Francisco Bay Area, CA, USA
Asked on: Thursday, February 24, 2011 at 3:08 pm EST
Answered on: Tuesday, May 14, 2024 at 2:00 am EDT
Question: I don't have a lot of experience with limited energy building wiring systems and codes, so to be honest I'm just looking to short-cut on some code research here.I have a client who has a 24VDC control circuit for Building Automation. They wired some basic switches to manually override some control contactors and only ran the +24VDC to and through the switches. Now they decided they want an indicator light at the switch to indicate when the switch is left On, but they have no common conductor in the box. They have been told by others that they can just connect the other side of the lamp to ground and that's OK, because the 24VDC power supply is grounded on that side (-) anyway. I know in regular 120V building wiring that is not allowed, but being that it's "Limited Energy" 24VDC, are there different code rules that allow Ground to be a current path?
In limited energy building wiring systems, the grounding conductor is not typically used as a current path for normal operation. However, there are some exceptions to this rule.According to the National Electrical Code (NEC), Article 725.121(B), the grounded conductor of a Class 2 circuit may be used as a current path for fault conditions or overvoltage protection. This means that the grounded conductor can carry current if a fault occurs, such as a short circuit or a surge.However, the NEC does not allow the grounded conductor to be used as a current path for normal operation of a Class 2 circuit. This is because the grounded conductor is intended to provide a path for fault currents, not to carry normal operating current.In your case, the client wants to use the grounded conductor as a current path for an indicator light. This is not allowed by the NEC. The indicator light must be connected to the positive side of the 24VDC power supply and the negative side of the power supply must be connected to the grounded conductor.I recommend that you advise your client to connect the indicator light as described above. Using the grounded conductor as a current path for the indicator light is not allowed by the NEC and could create a safety hazard. Flag for review