User: 451F, Location: Work in Maryland, Virginia, West Virginia, DC.
Asked on: Thursday, February 24, 2011 at 5:14 pm EST
Answered on: Tuesday, May 14, 2024 at 2:00 am EDT
Question: What are possible sources for a triangle waveform between pipes in a residential neighborhood? The frequency was ~60 HZ. (59.63)Arcing has perforated a copper pipe that was touching a steel drain pipe. There is about 1 volt difference between the pipes now as measured on the Low Z setting on a Fluke 117 DMM. The copper pipe tested as bonded to the building electrical system.The steel drain is connected to the sinks with plastic traps so there is not the usual short between drains and copper.The voltage difference varied over time with no relationship to equipment cycling in the building.Thanks in advance for your time and comments.
Induction from a nearby electrical conductor. This is a common cause of triangle waveforms between pipes, and it can occur even if the conductor is not directly touching the pipes. The magnetic field from the conductor can induce a current in the pipes, which can then cause a voltage difference between them. Corrosion. Corrosion can create a conductive path between pipes, which can then allow current to flow between them. This current can cause a voltage difference between the pipes. A faulty electrical connection. A loose or damaged electrical connection can also cause a voltage difference between pipes. This is because the loose connection can create a high resistance path for current to flow, which can then cause a voltage drop across the connection. A ground loop. A ground loop occurs when two or more electrical circuits share a common ground path. This can cause current to flow between the circuits, which can then cause a voltage difference between the circuits.In your case, the most likely source of the triangle waveform is induction from a nearby electrical conductor. This is because the frequency of the waveform is approximately 60 Hz, which is the frequency of the electrical power in your home. The fact that the voltage difference varies over time also suggests that the source of the waveform is not a constant current source, such as a battery.To confirm that the source of the waveform is induction, you can try to move the pipes away from any nearby electrical conductors. If the waveform disappears or decreases in amplitude, then it is likely that the source of the waveform is induction. Flag for review