Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Over current relay

User: newt, Location: Charlotte, NC

Asked on: Thursday, February 24, 2011 at 6:55 pm EST
Answered on: Tuesday, May 14, 2024 at 2:00 am EDT

Question: How is it possible to have a time over current / instantanous relay for a self contained 15 kv breaker trip only once for instantanous and then trip on time overcurrent? The breaker is 50 years old and the relay is an iac50/51. The reclosing timer is also located in the breaker and we block the instantanous part of this relay for down stream fuse coordination. I don't know why we block the instantanous if we are able to shut it off after it trips once. I was told this was possible.

It is possible to have a time overcurrent/instantaneous relay for a self-contained 15 kV breaker trip only once for instantaneous and then trip on time overcurrent. Here's how it works

1. Instantaneous Trip:

- When a fault occurs, the instantaneous relay detects the sudden surge in current and initiates a trip signal.- This trip signal is sent to the breaker, causing it to trip immediately, typically within a few milliseconds.2. Time Overcurrent Trip

- After the instantaneous trip, the time overcurrent relay takes over.- It measures the sustained overcurrent condition and compares it to a pre-set time-current curve.- If the overcurrent persists for a time longer than the set time, the relay initiates another trip signal to the breaker.

3. Block for Downstream Fuse Coordination

- Blocking the instantaneous trip for downstream fuse coordination is done to prevent the breaker from tripping instantaneously for faults that should be cleared by downstream fuses.- By blocking the instantaneous trip, the breaker gives the downstream fuses sufficient time to operate and clear the fault.

4. One-Shot Instantaneous Trip:
- Typically, the instantaneous trip is designed as a one-shot function.- After the initial instantaneous trip, it is automatically reset and disabled.- This prevents the instantaneous trip from operating again for subsequent faults, ensuring that the breaker trips on time overcurrent instead.Regarding your specific question, it is possible to shut off the instantaneous trip after it trips once. However, this is not recommended because it defeats the purpose of the instantaneous trip, which is to provide fast protection against severe faults. By shutting it off, you are increasing the risk of damage to the equipment or injury to personnel in the event of a major fault.It is important to maintain and test the relay and breaker regularly to ensure proper operation and adherence to protection coordination principles. Flag for review

Previous Question Next Question