Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Appliance pigtail being cited as incorrect

User: BMacky, Location: Foster City, CA

Asked on: Friday, February 25, 2011 at 6:10 am EST
Answered on: Tuesday, May 14, 2024 at 2:02 am EDT

Question: OK, I will try to make this one short: had an inspector look into an upper cabinet above an exhaust hood in a newly-remodeled kitchen. The hood is over an electric range. I attached an appliance pigtail to the top side of the hood and ran it up into the cab as you would for a microwave, and have a dedicated outlet inside the cab. Idea was future built-in microwave, and mfr required dedicated circuit for hood, so went with a receptacle here.Inspectors issue with the set-up: "You can't go from a 12-2 (feeding the outlet), to a 16 gauge appliance pigtail and down to 18 gauge wire in the fixture. That's 2 steps down. I'd accept one step down but not two." (he's speaking of conductor sizing). Hello? Am I missing something?We are talking about ampacities and conductors, I guess? I was not standing the inspection, so no request for a reference on this. Can anyone tell me if there is some other Code issue I am not aware of here? Seems to me that he is talking about wire size only and NOT ampacity of wire types. It's an appliance, just like slapping a pigtail on a dishwasher.Help needed, and thanks in advance. (Looking for a sanity check mainly)

Sanity Check

The inspector's concern about conductor sizing is not supported by the National Electrical Code (NEC). Here's why:

Ampacity vs. Wire Size

The NEC focuses on ampacity (current-carrying capacity) rather than wire size.


Appliance Rating

A dedicated circuit for an appliance (e.g., hood) is sized based on the appliance's rating.

Pigtail Use

Appliance pigtails are rated for ampacities up to 20 amps, which is sufficient for most kitchen appliances.

Applicable Code Provisions



NEC 404.2(B)

The wiring of a branch circuit supplying an appliance receptacle shall be not smaller than the circuit conductors, unless otherwise permitted.

NEC 402.11

Approved appliances shall be connected using an appliance cord, a flexible cord, or a fixed wiring method. The wiring method selected shall be appropriate for the intended use.

Your Situation

The 12-2 NM cable feeding the outlet complies with the ampacity requirements for the dedicated circuit. The 16-gauge pigtail from the hood to the outlet is also rated for the ampacity of the hood. The 18-gauge wiring in the hood is appropriate for the intended use, as it is within the ampacity rating of the pigtail.

Conclusion:


The inspector's concerns about conductor sizing are unfounded based on the NEC. The use of a 12-2 feeder, a 16-gauge pigtail, and 18-gauge wiring in the hood is acceptable and compliant with the Code. Flag for review

Previous Question Next Question