Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: class 1, div 2 devices in class 2 div 1 location

User: jimmy_mcquade, Location: Mission Viejo, CA

Asked on: Friday, February 25, 2011 at 12:11 pm EST
Answered on: Tuesday, May 14, 2024 at 2:03 am EDT

Question: Hi all,I saw dad pulling out the code book looking at the hazardous section and i startedasking questions. Now i am studying the hazardous code.Dad showed me the ul rating certificate number for a design he is doing. i then went to the website and started reading.My question is this, is a class 1 div 2 device such as a pushbutton ok to use in a class 2, div 1 area? i read in 500.7D that a purged/pressurized system would makedevices acceptable for the envorinment for devices that are not listed for the environment so i am going to say yes.But would they be acceptable if you didn't have a purge/pressurized system?Class 1 is a gas, but this is a class 2 dust. Doesn't the class 1 requirements make it satisfactory for class 2 since its more strict?thanks in advance,jimmy

Is a Class 1 Div 2 Device Acceptable in a Class 2 Div 1 Area?Short Answer

No, a Class 1 Div 2 device is not acceptable in a Class 2 Div 1 area without a purge/pressurized system.

Explanation

Class 1 and Class 2 hazardous locations have different requirements because they involve different types of hazards:

Class 1

Flammable gases, vapors, or liquids


Class 2

Combustible dustsClass 1 Div 2 devices are designed to operate safely in areas where there is a potential for occasional flammable gas or vapor leaks. Class 2 Div 1 devices are designed for areas where dust is continuously present in the air.The National Electrical Code (NEC) requires that electrical equipment be suitable for the specific hazardous location in which it is installed. In this case:

NEC 500.7D

Purged and pressurized systems can be used to make equipment suitable for use in more hazardous areas than it is listed for.


NEC 500.8(C)(1):
Class 1 and Class 2 hazardous locations are considered "different locations" and require different equipment.Therefore, even though the Class 1 Div 2 device may have a higher rating in terms of flammability, it is not suitable for a Class 2 Div 1 dust area without a purge/pressurized system to mitigate the dust hazard. Flag for review

Previous Question Next Question