Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: structual foam block

User: laketime, Location: Henrico County, VA

Asked on: Friday, February 25, 2011 at 4:21 pm EST
Answered on: Tuesday, May 14, 2024 at 2:04 am EDT

Question: Anybody ever rough outlets into this stuff? How did you do it? How long about per opening?

Roughing In Outlets into ICF Blocks



Method 1: Using a Drywall Saw
Materials

Drywall saw with a coarse blade Safety glasses Gloves

Steps

Mark the location of the outlet box on the ICF block surface. Score the outline of the box using a utility knife. Use the drywall saw to cut along the score lines, removing the foam insulation and leaving a cavity for the box. Allow for extra space around the box for mudding and drywall.

Time estimate

10-15 minutes per opening

Method 2: Using a Carbide Hole Saw
Materials

Carbide hole saw (diameter of outlet box) Drill Safety glasses Gloves

Steps

Mark the location of the outlet box on the ICF block surface. Use the hole saw attached to the drill to cut a round hole at the marked location. Cut deep enough to remove enough foam insulation for the box to fit. Allow for extra space around the box for mudding and drywall.

Time estimate

5-10 minutes per opening

Method 3: Using a Knockout Tool
Materials

Knockout tool (for ICF blocks) Hammer Safety glasses Gloves

Steps

Mark the location of the outlet box on the ICF block surface. Position the knockout tool over the marked location. Use the hammer to strike the knockout tool, removing a section of the foam insulation and leaving a cavity for the box. Allow for extra space around the box for mudding and drywall.

Time estimate

3-5 minutes per opening

Tips:
Wear safety glasses and gloves for all methods. Use a coarse blade for the drywall saw to avoid tearing the insulation. Cut slightly larger than the outlet box to allow for mudding and drywall. Use a sharp carbide hole saw for Method 2 to ensure a clean cut.* Be careful when using the knockout tool to avoid damaging the ICF block. Flag for review

Previous Question Next Question