User: romex jockey101, Location: Austin, TX
Asked on: Friday, February 25, 2011 at 7:19 pm EST
Answered on: Tuesday, May 14, 2024 at 2:04 am EDT
Question: i have a friend who was trying to get a then end of a bulb that was stuck in a keyless light fixture he thought the breaker was of when he went to pull out the end of the bulb it ark and shorted the circuit so i went to replace the ficture with anouther keyless holder when it cam time to flipping on the breaker i could not trace the bracker i fliped every breaker in the panel and it still wont go on none of the breakeres are in the triped position...i went to trace the homerun back to the panel but could not locate it bc its feed from anouther room ..the light is in the same room as the panel ..any ideas
Troubleshooting Steps
1. Double-Check Breakers
Verify that all breakers have been reset, including those with hidden trip buttons on the side. Try resetting the main breaker as well.
2. Test for Power
Use a non-contact voltage tester to check for power at the light fixture wires. If no power is detected, the problem may be elsewhere in the circuit.
3. Check for Loose Connections
Inspect all connections in the light fixture, feeder wires, and panel for any loose or damaged wires.
4. Trace the Circuit
Since the circuit is fed from another room, it may be difficult to locate the homerun. Try using a circuit tracer to identify the path of the wires. Alternatively, you can look for other lights or outlets that are not working in the same room or neighboring rooms, as they may be on the same circuit.
5. Inspect the Panel
If you cannot locate the circuit at the light fixture, check the distribution panel again. Look for any double-tapped breakers (two wires connected to one breaker) or any breakers that are labeled incorrectly.
6. Check for Arcing
If you suspect that the short circuit caused arcing, inspect the wires and panel for any signs of burning or charring. Arcing can damage breakers and wires, even if the breaker did not trip.
7. Contact an Electrician
If you are unable to locate the problem, it is recommended to contact a certified electrician. They have the expertise and equipment to safely troubleshoot and repair the circuit.
Additional Tips: Make sure to turn off the power at the main breaker before attempting any troubleshooting or repairs. Use caution when working with electrical circuits, as even small shorts can be dangerous.* If you are not comfortable working with electricity, it is always safer to hire a professional. Flag for review