User: ocoee, Location: Golden Co
Asked on: Saturday, February 26, 2011 at 12:24 pm EST
Answered on: Tuesday, May 14, 2024 at 2:06 am EDT
Question: Is it a code violation to use a electrical panel as a junction box?Recently the electrician wiring a residence brought several circuits to a single panel instead of splitting them between the two panels located next to each other. Can I simply run a conduit between the panels and extend the wiring to the second panel? The house is finished, the general contractor would rather I not open up the wall to install a junction box.For the record I would rather open the wall and install them properly as this is new construction. Unless I can site a code violation ,he will not be agreeableThanks All!
Yes, it is a code violation to use an electrical panel as a junction box.
According to the National Electrical Code (NEC) Article 312.8:> "Enclosures for overcurrent devices shall not be used as junction boxes, auxiliary gutters, or raceways for conductors feeding through or terminating within the enclosure unless conductors are introduced solely through knockout openings."This means that electrical panels should not be used to connect or distribute conductors, except for those that terminate within the panel. Using a panel as a junction box can create hazards, including: Overcrowding
Panels are designed to hold a specific number of circuits and devices, and exceeding this capacity can lead to overheating and electrical fires.
Safety concerns
The panel cover is not designed to provide protection for splices or connections, which could increase the risk of electrical shock or short circuits.
Code compliance
Using a panel as a junction box violates the NEC and may invalidate the electrical inspection and permit.
Solution
To resolve this issue, it is recommended to install a proper junction box between the two panels. This will provide a safe and code-compliant way to connect and distribute the circuits.
Additional Information: While opening up the wall may not be ideal, it is the proper way to install the junction box. The general contractor's preference should not override code requirements and safety considerations. If the electrician is unwilling to make the necessary repairs, it is recommended to contact the local code enforcement authority for assistance. Flag for review