User: stlcardinalsguy, Location: Massachusetts
Asked on: Sunday, February 27, 2011 at 12:55 am EST
Answered on: Thursday, May 23, 2024 at 5:51 pm EDT
Question: Hi all! I recently had a service disconnect installed in my home and would like to know if it has been wired correctly. The electrician I hired seemed like he didn't know what he was doing and my lights now dim when the furnace kicks on...they didn't do this before! I'm thinking it might be a grounding issue, so I roughed up a crude diagram for y'all to look at. The service disconnect is directly below the meter outside the house which is grounded with the existing ground rod. Inside the house, the service panel was grounded to the city water pipe.The electrician used 4/0-3 aluminum SEU to run from the disconnect to the main service panel inside. I'm pretty sure the bonding is correct in the disconnect (neutral to ground), but should there be an extra ground introduced in the service panel? He ran a 4AWG solid copper line from the inside service panel to the water line which wasn't there before. Is this correct?
## Service Disconnect Wiring EvaluationBased on your description and diagram, it is possible that the service disconnect wiring is incorrect, which could be causing the lights to dim when the furnace kicks on.
Grounding Issues Outdoor Disconnect
The neutral and ground should be bonded at the service disconnect. This ensures that the neutral wire is at the same electrical potential as the ground wire.
Indoor Service Panel
According to the National Electrical Code (NEC), there should be a separate grounding electrode conductor (GEC) connected to the service panel. This GEC should be connected to either a ground rod, a concrete-encased electrode, or the city water pipe. In this case, the electrician ran a 4AWG copper line from the service panel to the water line. While this could provide a grounding path, it may not be sufficient.
Bonding Outdoor Disconnect
The bonding jumper between the neutral and ground in the service disconnect is correct.
Indoor Service Panel
There is no mention of bonding between the neutral and ground in the indoor service panel. This bonding is required to ensure that the neutral and ground are at the same electrical potential throughout the house.## RecommendationsTo ensure that the service disconnect is wired correctly and the grounding issues are resolved, it is recommended to have a qualified electrician evaluate the installation and make the necessary corrections. They should: Verify the bonding in both the outdoor disconnect and indoor service panel. Ensure that a proper GEC is installed at the indoor service panel. This may require driving a ground rod or installing a concrete-encased electrode. Check the quality of the grounding connections at all points. Test the entire electrical system to verify proper grounding and bonding.
Additional Considerations The dimming of lights when the furnace kicks on may also indicate a loose connection or other electrical issue. The electrician should inspect the furnace wiring and connections. It is important to use a qualified electrician who is familiar with the NEC and local codes. Flag for review